Information on compliance with communication regulations

Declaration of conformity with FCC directive (USA). This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Declaration of conformity with FCC directive (Canada)

This Class A digital device is conformant with all the requisites of the Canadian directive relative to equipment causing electromagnetic interference.

Declaration of conformity with the European Union EMC Directive

Warning: this is a Class A product. In a domestic environment, this product may cause radio frequency interference in which case the user may be required to take adequate measures.

Declaration of conformity with EMCRCM regulations (Australia and New Zealand)

This product is conformant with the requisites of the EMC regulations applicable in Australia and New Zealand.

Homologation and safety regulations

Homologation may be necessary in certain countries to obtain authorisation to use transmitters in certain frequency bands. Contact your local authorities or your dealer for more information. Unauthorised modification of the device may void homologation and the warranty, and result in suspension of authorisation to operate the device itself.

The receiver contains an internal radio modem which may potentially transmit signals. As legislation varies from country to country, contact your dealer and the local authorities for information on the frequencies the device is permitted to use. In certain countries, legislation may require the purchase of a license to use certain frequencies.

Radio and TV interference

This equipment generates, uses, and can radiate radio frequency energy. If not installed and used correctly in strict accordance with the instructions provided by SDF, this equipment may cause interference with radio communications.

To ascertain if interference is caused by this equipment, switch off the iMonitor and check if the interference stops.

If this equipment causes interference with a radio or any other electronic device, try the following:

• Adjust the orientation of the radio aerial until interference stops
• Move the equipment to the other side of the radio or electronic device
• Move the equipment away from the radio or electronic device
• Connect the equipment to another power circuit not connected to the radio.

To reduce potential interference, use the equipment with the lowest gain setting which still permits adequate communication.

If necessary, contact your nearest SDF dealer for assistance.

Note: any modifications or alterations to this product made without prior authorisation from SDF may void the conformity of the product with the EMC, resulting in the suspension of authorisation to use the product itself.

This product has been tested to ensure conformity with the EMC Directive using SDF peripherals, shielded cables and connectors. It is important to use SDF products to connect between components of the system to minimise the possibility of interference with other devices.